Hello, I was encounterning a problem using the MiniTiouner Express hardware and any version of the software. Starting the software I always get the message "Hardware incompatible, we quit". Tried to uninstall and reinstall drivers and it worked, but after PC restart I get the same problem again, very annoying!
Finally I have found that this is caused by other USB Serial Converter attached on my PC with FTDI Chip. So the software will probably try to connect to other devices using the FTDI chip and does not find the correct product description.
I think this is a software bug and need a correction since it's very common to have other FTDI devices like USB to RS232 or in my case it's the rotator USB interface connected to my pc.
Is this known? Any solution? If not I guess a next release will need to address this problem.
Thanks, Mauro IW3ROW