[DL4OCH]

I've received 2 of them this Monday and all was fine.

Boxed and air-padded as well. No damage at all.

So, either you had bad luck, or I was on the lucky side... Who knows...


Best,
Wilm, DL4OCH

[F6DZP]

Hello,

Full schematic for MiniTiounerpro V1 is here. http://www.vivadatv.org/viewtopic.php?f=83&t=442

I will put the MiniTiounerProV2 schematic ASAP, it is similar, but with 2 RT5047 instead of only one for the MiniTiounerpro V1.

The L12 or L212 with some part of ferrite broken is not very important, I continue to use one MiniTiounerPro with a ferrite broken and I have no difference.
They are used with the RT5047 that produce the 13/18v.


Jean-Pierre F6DZP

[G3UEQ]

Hi Andy,

I have mine working ok now as far as I can tell - it also had a few bent pins on the headers, nothing serious but indicative of inadequate packaging which likely results in the ferrite inductors getting damaged.

While mine is working ok now I suspect it may have an intermittent somewhere - I'll keep a close eye on it while I await the case and display I've ordered.


73 Tim

Tim
Glad yours is working OK now, my cases arrive today, yes, I liked them so got two for other projects, the display around middle of June and PCB about end of June!

73
Andy