[3b8fa]

Minitouner V0.9.9.1
When I use "Check Minitioune Driver and Filters" all is OK (all green lights ON)
When I use "Test my Minitiouner V2.3" It can't see Minitiouner and I get "Bad config" message ?? (check pic)
When I try to run Minitiouner I get "Hardware incompatible,we quit" message.
Thank you for your suggestions and help.
73s
Pat

[F6DZP]

Hello ,
I can't help you for the moment.

MiniTiouner is the hardware
Minitioune is the software.

there are different models of MiniTiouners : V1, V2, Pro, S ...

So first : which MiniTiouner you are talking about?

I just can say that you have a problem with the hardware. Your MiniTiouner is not recognize.

Jean-Pierre F6DZP

[3b8fa]

Hi Jean Pierre,
thank you for your time,I have the MinitiounerPro2

[F6DZP]

If you have a MiniTiouner Pro V2, the FT2232H is already programmed. So you don't have to use FTprog.

I see that you have used FTprog and have erased the good parameters for a MiniTiounerPro V2 so it is normal that the software to check the hardware doesn't recognize your MiniTiouner.
You need to re program the FT2232H with the good template.
http://www.vivadatv.org/download/file.php?id=1118

you have 2 template, one for the FT2232H master, one for the FT2232H aux.

Jean-Pierre F6DZP

[3b8fa]

Hi Jean Pierre,
I surely went wrong somewhere, here is what I obtained after programming FT2232H with the new templates.

FTProg Device Tree

Port A
Hardware ---> RS232 UART
Driver ---> D2XX Direct

Port B
Hardware ---> 245 FIFO
Driver ---> D2XX Direct

PSE check screenshot

[F6DZP]

all is wrong

[3b8fa]

Hi Jean Pierre,
I tried a few times again and finally got it working good, as you probably understood I'm not very computer wise, so it takes some time to
have things working.
Anyway thank you for the time you spend replying to all request, your devotion is greatly appreciated.
Best 73s
Pat
3b8fa